Worcester Si Mk II Manual de instrucciones descargar pdf (Pagina 27)

DIGISTAT

INSTALLATION

DIGISTAT / DT20RF RECEIVER

TO CHECK PREVIOUSLY

INSTALLED UNIT

To check signal strength on previously

installed and paired units :

1. Press the ‘set’ button 4 times.

2. Press ‘OK’ once.

3. Press the ‘set’ button 5 times. The display will

show ‘SSI and OFF’.

4. Press the ‘+’ button so that the display shows

‘SSI, Antenna and ON’.

5. Press the ‘set’ button so the display shows ‘SSI

and Antenna’.

6. After a few seconds the display will show ‘---’.

7. Remove the batteries from the transmitter and wait

until the display has faded away.

8. Press and hold the SET button on the transmitter

while re-inserting the batteries and keep the

button depressed until the display shows ‘rF’ .

DT20RF PROGRAMMER

INSTRUCTION MANUAL

8 716 115 495a (02.2009)

OPERATING & INSTALLATION

INSTRUCTIONS

8_716_115_495a 9/2/09 11:49 Page 27

1 2 ... 22 23 24 25 26 27 28 29 30 31 32

Sin comentarios

Worcester Si Mk II Manual de instrucciones Pagina 27